1
2
Glue the cut-to-size ELEMENTS-EL 50 to the wall with COL-AK such that they can be vertically and horizontally aligned.
3
The spacing of the cut ELEMENT component parts should be between 30 – 40 cm.
4
Apply COL-AK to the face end of the levelling construction and glue on correspondingly cut and notched ELEMENT-EL 20 in transverse position.
5
Glue the individual ELEMENTS-EL 20 by applying adhesive to the edges an joints. Be sure to observe the vertical and horizontal alignment of the ELEMENT construction panels!
6
NOTE: We recommend the pre-piercing of the dowel holes with a cross slot screwdriver.
7
The levelling construction can take place at full room height or with a shelf above the installations. ELEMENT-EL 20 is suitable for the top cover.
8
All element joints and transitions are to be reinforced with ARM-100 SK glass fibre reinforcement strips. Then level out the element joints using COL-AK
It must be observed that, in the areas in which sanitary articles such as e.g. washbasins or WCs are later to be suspended and installed, the ELEMENT construction panels are to be glued over the full surface if possible – due to the high pressure absorption. According to the manufacturer’s instructions the load-bearing frames of the suspended WCs should be lined with bricks or planked with wooden boards to avoid torsion.
- Practical instructions
-
The basis
Quality with the environment in mind
Working with hard foam support elements
The tools
Recommended cutting techniques for the ELEMENT construction panel
LUX ELEMENTS®- ELEMENT EL
LUX ELEMENTS®- ELEMENT-SL / SQ
Bending radii, slit spacings, dimensions of pre-slit hard foam
Processing instructions with slit panels
LUX ELEMENTS®- ELEMENT-VK
General processing instructions
Processing tips
The following materials are suitable for cladding hard foam support elements
- Application areas
-
Walls in interior areas
Attaching to masonry, concrete or plaster with mortar
Wall levelling over existing tile coverings
The multi-functional construction panel: application on the wall (example)
Application on free-standing metalsupports
The multi-functional construction panel: application on metal stud frame (example)
Wall-mounted elements
The creation of a levelling construction
Planking of a support construction
Floor applications
Application on beton or screed
Application on wooden floor boards
Application on the floor
The multi-functional construction panel: on mineral substrate (example)
Floor shower base
- Construction & design
-
With straight panels
Partition walls or room dividers
With slit panels
- Practical examples
- Product
- Datasheets
-
LUX ELEMENTS®- ELEMENT-EL (411 KB) LUX ELEMENTS®- ELEMENT-SL/SQ 30, 50, 80 (134 KB) LUX ELEMENTS®- ELEMENT-VK (411 KB)
- Safety Data Sheets
-
- Installation instructions
- Product & packaging specs
- Systemcomponents
-
The proven and tested system components are fully matched to the processing of the hard foam support elements. The specially developed accessories ensure trouble-free working and high processing reliability.
LUX ELEMENTS®- ARM: Reinforcement fabric LUX ELEMENTS®- COL: Adhesives LUX ELEMENTS®- DRY: Sealing filler and sealing tapes LUX ELEMENTS®- FIX: Fastening sets and plugs/exterior LUX ELEMENTS®- MONT: Mounting aids
Before printing a pdf file, please check if this is really necessary.
Environmental protection concerns us all.
To view the PDF files, you will need Acrobat Reader that you can download here free-of-charge. This program will enable you to open, view and print out these documents in PDF format.