Floor applications - Application on beton or screed

1

The shorter Baby construction panels from ELEMENT-EL Baby 10 are suitable for this application.

Irregularities must be compensated using levelling filler. Do not forget the edge insulation strips. Allow the ELEMENT panels to adapt to ambient conditions such as temperature and humidity prior to installation.

2

The substrate must be load-bearing and vibration-free.

After preparation of the substrate, stick edge insulation strips circumferentially round all wall-floor connections.

3

Apply COL-AK fixing adhesive with a toothed trowel (depending on the substrate, at least 6 mm) to evenly cover the surface.

4

The ELEMENT panels are positioned close together in bond and pressed into the adhesive layer.

5

Dot laying is possible from EL 30. The spacing of the mortar dots should be approx. 20 cm.

6

Reinforce ELEMENT joints with ARM-100 SK ...

7

... and level out with COL-AK. Use the fluidised thin bed adhesive COL-FBK or COL-FLEX for the cavity-free installation of tiles.
NOTE: When applying in damp or wet rooms it is necessary to use an additional LUX ELEMENTS®-DRY-ASK or DRY-DF sealing in conjunction with ceramic coverings. Use the fluidised thin bed adhesive COL-FBK or COL-FLEX for the cavity-free installation of tiles.

A total pressure load of 0,1 N/mm² must not be exceeded.
When using for higher loads such as transport traffic, rack
systems etc., please contact the LUX ELEMENTS technical department.

Also suitable for heating systems due to continuous temperature resistance up to +75°.

The universal construction panel

Product

LUX ELEMENTS®- ELEMENT

Datasheets

LUX ELEMENTS®- ELEMENT-EL (411 KB) LUX ELEMENTS®- ELEMENT-SL/SQ 30, 50, 80 (134 KB) LUX ELEMENTS®- ELEMENT-VK (411 KB)

Safety Data Sheets

Installation instructions

LUX ELEMENTS®- ELEMENT-EL VK (183 KB)

Product & packaging specs

LUX ELEMENTS®- ELEMENT (51 KB)

Systemcomponents

The proven and tested system components are fully matched to the processing of the hard foam support elements. The specially developed accessories ensure trouble-free working and high processing reliability.

LUX ELEMENTS®- ARM: Reinforcement fabric  LUX ELEMENTS®- COL: Adhesives  LUX ELEMENTS®- DRY: Sealing filler and sealing tapes  LUX ELEMENTS®- FIX: Fastening sets and plugs/exterior  LUX ELEMENTS®- MONT: Mounting aids


Before printing a pdf file, please check if this is really necessary. Environmental protection concerns us all.

To view the PDF files, you will need Acrobat Reader that you can download here free-of-charge. This program will enable you to open, view and print out these documents in PDF format.

 
... nach oben

© 2019 All rights reserved. We reserve the right to make technical changes.
Status: 03.04.2019

back
KontaktformularPrint this page!
powered by webEdition CMS